SEARCHING FOR AND TEMPORARILY STORING ACTIVE FREQUENCIES Repeat Steps 1-4 to program more channels or Steps 2-4 if you want to program the next channel in sequence. If you make a mistake in Step 3, ERROR appears on the display. Using the number keys, enter the frequency you want to store in that channel. Enter the channel number you want to program.Ģ. Follow these steps to store frequencies.ġ. You can store up to 200 frequencies into the scanner's channels. If you do not have a reference to frequencies in your area, you can use a limit or direct search to find a transmission.
Radio shack 200 channel scanner pro 51 manual update#
Good references for active frequencies are Radio Shack's "Police Call Radio Guide Including Fire and Emergency Services," "Official Aeronautical Frequency Directory," and "Maritime Frequency Directory." We update these directories every year, so be sure to get a current copy. To turn on banks while scanning, press the bank's number key until the bar appears under the bank's number. SKU: RCI2970N4 Buy Cobra 29 LX 40-Channel CB Radio with Instant Access 10. You can manually select any channel in a bank, even if the bank is turned off. Amateur Transceiver 95 Ranger : Ranger 2950CD 10 Meter Mobile Radio The New. The scanner does not scan any of the stored channels within banks you have turned off. To turn off banks while scanning, repeatedly press the bank's number key until the bar under the bank's number disappears.
As the scanner scans a bank, the bar under the bank's number flashes. When you first turn on the scanner, the scanner scans all ten channel storage banks. NOTE: An improper SQUELCH setting might keep the scanner from scanning (see "Turning on the Scanner/Setting Volume and Squelch"). The scanner scans either up or down through all non-locked channels in the active banks (see "Locking Out Channels"). To begin scanning the channels or to start scanning again after monitoring a channel, press SCAN. If you want to listen to a weak or distant station, turn SQUELCH counter-clockwise. NOTE: If the scanner picks up unwanted weak transmissions, turn SQUELCH clockwise to decrease the scanner's sensitivity to these signals. Slowly turn SQUELCH clockwise, then leave it set to a point just after the hissing stops. The scanner automatically scans all 10 banks.ģ. Turn VOLUME clockwise until you hear a hissing sound. While holding down 3 and E, turn on the scanner.Īfter several seconds, the scanner restores the frequencies and -LoAd- appears.TURINING ON THE SCANNER/SETTING VOLUME AND SQUELCHĢ. Use this procedure only when you are sure you do not mind erasing the current channel memories.įollow these steps to load the 150 frequencies. You can load the frequencies in Channels 1 to 150.Ĭaution: This procedure overwrites all channel memories. Your scanner has 150 most frequently used frequencies (not the preloaded race frequencies) in special permanent memory. After about 3 seconds, the scanner initializes and CLEAr appears. While holding down 2, 9, and HOLD, turn on the Reset the scanner only when you are sure it is not working properly.
Before you reset the scanner, try turning it off and on to see if it begins working properly. If the scanner’s display locks up or stops operating properly, you might need to reset the scanner.Ĭaution: This procedure clears all the information stored in channel memories including the race frequencies.
0 kommentar(er)
